Plywood is a set of sheets usually made of vertical sheets in the direction of adjacent layers of wood, usually symmetrically configured on the center layer or on both sides of the core.
So how do you solve the defects that arise when the plywood saw sands?
1. If the track pressure on both sides is not consistent, or the pressure on both sides of the drum is inconsistent, then the pressure should be adjusted.
2, if the plywood has one side clip saw, then it is necessary to check the saw opening, replace the saw blade.
3, if the plywood warping is too large, then the plywood is flattened and then sawed edge.
4. If the blade position is not fixed, then it is necessary to stop checking and adjust the blade position.
5, if the feed speed is too fast, then it is necessary to adjust the feed speed, increase the allocation of material, deepen the groove.
6, if the serrated profile is too narrow, then the tooth groove is too shallow, improve the cutting speed.
7, if the cutting speed of the blade is low, then the blade diameter is small or low speed.
8. If the blade installation offset, then check and correct the blade installation status.
9, if the individual serrated profile is not accurate, then it is necessary to correct the serrated teeth of the dial.
10. If the serrated grinding angle is not correct, then the grinding of serrated teeth as required.
11. If the serrated blade is not sharp, then it is necessary to re-grind or replace the sharp blade.
12, if the plywood pressure is too tight (roller type), then it is necessary to adjust the compression device.
13, if the blade dial is too large, there are flying teeth, then it is necessary to check the blade, correct the dial.
14, if the military industry reported that the water content is too low, then it is necessary to check the water content of plywood.
15. If the bezel is not installed correctly, the bezel position should be corrected.
16, if the middle of the blade soft shake, then it is necessary to replace the blade, the blade will be re-flattened.
17, if the serrated height is different, not in the same circle, saw blade warp jitter, then, check the saw blade, pickaxe tip, correct repair saw blade.
